Profile: Electrex Industrial Services specializes in offering complete industrial services. We can move the existing facility or design and build a completely new one from the ground up. From finishing systems to controls and automation, from back-up power generation to equipment foundations, from moving a single machine to integrating & building complete systems, we cover all industrial services. From aerospace to automotive, fabrication to forging, even medical to manufacturing, we service all industries. The Rexcon brake sentry is a user programmable, stand alone unit designed to monitor press starting and stopping times. The brake sentry also has the capability to perform a 90°/270° or a 70°/250° stop time test. This test allows the user to not only check the stopping time of the press but also allows the user to see if the counter balance pressures are set correctly. It has an available auxiliary motion output for use with systems that have a need for an additional make and break signal on each start & stop stroke of the press. The unit is built around a microcomputer running at 12 MHz and is capable of executing up to one million instructions every second. System integrity is maintained using a hardware watch dog timer which monitors the microcomputer operation and resets everything if any problems are detected. The microcomputer contains 8k of programmable read only memory (PROM) and has a separate non-volatile memory chip capable of storing the user entered parameters for 10 years without power. Our automation products include brake monitors, press controls, light curtains, robotic cells, safety fencing, vision systems, general machine controls, destacking systems, robotic press lines, metal finishing controls, conveyor systems and facility automation controls. Our process piping capabilities include water process piping, hydraulic lines, pneumatic piping and air compressor & dryer system piping.