Transfer Plates has the crucial role of connecting the SLM line to the transfer line. It can be attached to the EMU structure by three leveling. The components can be reduced to the bare minimum, to include only two 2-D sensors, 1 cross-hair laser module, and three leveling screws.

Transfer Pumps are usually vertical canned pumps to accommodate the suction liquid at its saturation pressure and temperature. These pumps are used wherever fluids have to be transferred from one repository into another one.

Transfer switches can generally be classified as manual, automatic, high-speed mechanical and static. Manual transfer switches require a human operator. As such, switching will generally require a minimum of several minutes to accomplish. These devices are relatively inexpensive, but may not provide adequate reliability to loads and processes vulnerable to extended interruptions. Automatic transfer switches have the ability to immediately sense loss of voltage on the primary feeder and switch over to the secondary feeder in a matter of seconds. Critical loads are often connected to more than one source through the use of a transfer switch. The load is normally connected to a primary feeder and is transferred to a secondary feeder if the primary feeder experiences an outage. Typically, transfer switches consist of two interlocked switches that prevent both switches from being closed at the same time.

Transfer Tape Dispenser works on smooth surfaces. It applies a precise strip of adhesive. It attaches signs, tags and placards to warehouse skids and racks. The rods are mounted for quick insertion and removal to enable rapid change of tape rolls. It is used for foam tapes and has a secondary roller that automatically rewinds the backing liner.