Spray Chill Systems produces controlled release flavoring and coloring agents. The apparatus and processes for obtaining generally solid flavoring and coloring agents which can be used to release flavors and aromas and coloring in a balanced manner. The unit consists of an electromechanical system and a data acquisition/control system. Design concepts for the spray chill system are versatility, rapid change of spray parameters, and computer control of the electromechanical system.

Spray coatings are suitable for thin-film photo resist applications on non-traditional wafers and MEMS devices. It uses a nozzle-less ultrasonic spray head and a high-performance X-Y-Z motion control platform when applying a thin, uniform coating of photo resist when spin coating is ineffective.

Spray condenser is an injection condenser in which the steam is condensed by a spray of water, which mingles with it. A spray condenser is a type of direct-contact condenser. One advantage of such a condenser is that it is relatively simple and inexpensive to produce. It also offers a greater efficiency than shell and tube condensers, due to a greater surface area for heat transfer produced by the droplets. The method is simple, water cooled below the dew point of the air in the condenser is sprayed at an optimum droplet size, and the water vapor condenses while releasing a latent heat of condensation. This latent heat can be utilized by a heat exchanger, and thus converted into energy for other uses in the desalination process. Also increasing efficiency, part of the exit stream of water leaving the condenser may be recycled and used as the spray for the humid air.

Spray Cooling Baths are made from stainless steel with lateral covers of soft PVC. It has effective cooling length. It has choice of 100mm or 200mm diameter capacity.

Spray drying is a technique, which is used to produce spherical materials. It can be used as an intermediate process for drying and producing free-flowing powders, or as a real shaping technique producing attrition-resistant spherical particles with a diameter between 10 and 100 µm. These particles are used in fluidized beds. In a spray dryer, a hydrogel solution is sprayed through nozzles into a heated zone. Depending on the temperature, either drying or both drying and calcinations occur as the drops fall. There are also spray dryers with a nozzle blowing upwards, like a fountain. The type of liquid atomizer is very important for the maximum attainable particle size and the broadness of the particle size distribution.

Spray Fluxers are manufactured by stainless steel and titanium parts and features a magnetically driven nozzle assembly. It delivers high-quality spraying performance that ensures uniform wetting and through-hole penetration/top side wicking without excess deposition or flux waste. It saves more than 60% of flux over comparable foam-type fluxers.