Air intake flow meter is for measurement of engine air intake in pipes 3″ and larger. An integral RTD, and external pressure input allow the embedded microprocessor to provide compensated mass flow readings. This meter is ideal for engine air intake flow measurement in line sizes up to 4″ in diameter. It is used for engine air intake, emission analysis, flow/calibration benches, leak detection and mass flow measurement applications.

Air Intake Vents are used for the cowl opening of an armored vehicle which consists of a front armor plate extending upwardly from the cowl. A front flange of the cover extends downwardly in front of the front armor plate preferably with an inclined orientation so as to provide good deflection of projectiles away from the cowl opening. A pair of side armor plates extends upwardly from the cowl on opposite lateral sides of the opening and side flanges on the cover extend downwardly outboard in a spaced relationship. The holder for the air filter includes an L-shaped rear mount that positions the rear extremity of a mounted filter such that the front and side extremities thereof are respectively positioned by the front and side armor plates on the cowl.

Air jack systems are used for industrial lifting or jacking applications. These are built tough for continuous use in demanding rigging, manufacturing & production applications. These are all lightweight and portable so they are easy to handle, store, transport and set up. The low profile of the air-jacks requires only one inch (25.4mm) of insertion space and inflate to full height in just seconds. They are available in a variety of sizes with single jack capacity up to 70 tons, (63.50 metric tons) & can provide virtually limitless lifting capacities when used in series. These are used under the most adverse conditions to relocate, align and position heavy machinery. Air jacks are especially good at interfacing with odd shaped loads.

Air Knife Drying Systems are fully automated conveyorised air knife systems for water removal on packaging/production lines. It uses a precision-engineered linear slot to direct and utilize high velocity air from a centrifugal blower. It provides air curtain/barrier and neutralizes static charges.

Airlift pump is a simple pump, which is powered by compressed air. Typically, the compressed air is pumped down a pipe into a well and bubbles into another larger diameter pipe. The air bubbles return to the surface in the larger pipe. Airlift pumps are often used in deep dirty wells where sand would quickly abrade mechanical parts. However airlift wells must be much deeper than the water table to allow for submergence. Air is generally pumped at least as deep under the water as the water is to be lifted. The airlift pump is a type of deep well pump, used to remove water from mines. It can also be used to pump slurry of sand and water or other gritty solutions. In the pump, the compressed air is piped down a shaft and the air then returns up a discharge pipe carrying water with it. The pump works by aerating the water in the discharge pipe.

Air Lifting Bags are extremely tough and made of neoprene embedded with three full layers of fiber reinforcement on each side, giving the bags tremendous strength at full inflation. These bags are designed to dynamically lift objects from depth & rise up through the water column dumping excess air from the open bottom as they ascend.

Air Lifting Winch has high-efficiency helical reducers plus high capacity. It has anti-friction bearings for long life, low noise and high output torque. Totally enclosed reducers make them weatherproof. The air motors can be stalled indefinitely under load without harm to the motor. The air break is a disc type that is activated automatically in the event of a power interruption.