Line Voltage Conditioners are designed to install directly to the utility power source to provide dedicated clean power to one or more outlets for a variety of equipment. This provides ideal protection in high noise areas where voltage fluctuations exceed the regulating range of the equipment/system power supply. They are available in power ratings from 250VA to 5000VA with a 120/240 output at 60Hz.
Line Voltage Monitors are designed to plug into any 120 v wall receptacle and provide a continuous, accurate reading of the A.C. The green zone on the scale indicates proper levels. These provide pre-start and running protection on the line side of the point of connection. These are used in 3-phase systems to protect motors and other loads against abnormal voltage/current conditions.
Line Wiper wipes fluids from the wire line and confines fluid pressures to the well bore. The line wiper is a handy tool. Line wiper helps maintain a clean running line, reducing maintenance time, minimizes wear & tear to sheaves in transport and made from anodized aluminum to protect against corrosion.
Line-type heaters are used for heating small to large volumes of liquids in-line. The liquid to be heated is accelerated through a specially designed narrow-angle full-cone converging nozzle, where it emerges at high velocity as a multitude of liquid droplets. These liquid droplets provide a considerably larger surface area upon which steam can condense than a solid stream of liquid of equal volume flow rate would provide. Steam is introduced into the liquid flow through the annular orifice formed by the outside of the liquid nozzle and the inlet to the diffuser section of the heater.