One of the ways of improving the efficiency of a water-washing system for solids removal is to combine the advantages of the cyclone with that of the simple scrubber. In cyclone scrubber, the dirty gas is swirled around a cyclone while liquid is sprayed toward the walls of the cyclone to knock the particles out of the gas stream. Cyclonic scrubbers use a variation of the spray scrubbers where the spray nozzles are arranged in a ring and spray toward the cyclone wall. These cyclones are as effective on small particles because their mass is not sufficient to cause them to fall to the bottom of the cyclones. By adding the liquid spray, the liquid impinges on the dust particles, which makes them heavy enough to fall to the bottom of the cyclone for collection.

Cyclone separation is a technique of removing particulates from an air or gas stream, without the use of filters, through vortex separation. It is a simple device with no moving parts, cyclone separators use centrifugal forces generated by a rapidly spinning gas to separate solids from air. Dirty air entering the cyclone is forced into a spiral motion where the centrifugal forces push the particulates to the outer walls of the device where they can be collected and discharged. Cyclones can be used as precleaners ahead of bag houses and can be designed to handle a wider range of chemical and physical conditions than almost any other type of collection equipment.

Cylinder Mould consists of a shaft on which number of flanges or spiders are assembled and support the copper wire mesh or fine bamboo mesh, which covers the surface of the cylinder. Cylinder mould formers are available for operating speeds up to 280 m/min.

Cylinder is a rotating device that contains the firing chambers of a revolver. A cylinder is in the central working part of a reciprocating engine, the space in which a piston travels. Multiple cylinders are commonly arranged side by side in a bank, or engine block, which is typically cast from aluminum or iron before precision features are machined into it. A cylinder's displacement, or swept volume, is its cross-sectional area times the distance the piston travels within the cylinder. The engine displacement is the swept volume of one cylinder times the number of cylinders in the engine.

The cylindrical bending leads to an increase in damping as the aspect ratio is increased. The most rectangular laminated plates having a high length-to-width ratio is analyzed as an infinite strip. The deformation of such a long plate under bending appears as a simple radius of curvature around a cylinder.

DC Dispersers is a electric mixer dispersers. Its features full wave rectifier, soft start acceleration, transient and surge protection, line voltage compensation, forward on or off switch, shear blade, variable transformer controller and mixing shaft speed. It has torque motors and SCR controllers.

Deep Bed Filters are used to filter water after it has been treated in a clarifier. They are used to remove organic matter, chlorine and very fine particulate matter. It is based on a support screen which is mounted a few inches above the bottom of the tank. The screen is perforated to allow water to flow through it. When the filter is in service, raw water is pumped in through a pipe that feeds a distribution pipe above the deep bed.