Vibrating machine is used for the preparation of mortar cube for the determination of compression strength of ordinary and repair hardening Portland cement and low heat Portland cement. Vibrating machine is suitable for preparation of mortar cubes for strength evolution. It consists of a frame mounted over coiled springs. A revolving shaft operates the whole assembly with an eccentric mechanism.

Vibrating point level switch is used for fine powders and granular solids. It is used in low-density solids, like EPS beads. Vibrating level switches for liquids are used to overfill and dry run protection system. It is used for detecting liquids in regular to harsh environments. It is also used for detecting dry and free flowing solids.

A vibrating-rod level switch specially designed for providing high or low level switching signals in silos or bins containing free-flowing powders and granular materials such as carbon black, sugar, grain, cement, lime, and sand with a material bulk density of 50 kg/m3 or more. These are integral units providing a low cost and reliable level detection of bulk solids in tanks or silos. This is ideally suited for level control on powders, granular or lump materials up to a minimum density of 0,05 kg/dm3.

Screens are used in classification of drier materials at coarser sizes. It is necessary to control the size characteristics of particular material that are fed to process equipment that separates mineralogical components. It presents a barrier to oversize materials while it readily passes the under size materials. Each material is given several opportunities to pass through the screen. The screen may be stationary or vibrating. The vibrating screens increase the rate of presentation of each particle and also assist in moving oversize particles away from the screen. The performance evaluation of the equipment depends on capacity evaluation as well as its efficiency of separation.

Vibration Absorbers are designed for installation in the suction & discharge lines of air conditioning and refrigeration systems to dampen the transmission of compressor-induced vibration through system piping. Vibration absorbers are used to attenuate vibrations of flexible blades in a bladed disk assembly. These absorbers are devices used to kill or reduce unwanted vibrations in mechanical or structural systems. Vibration absorbers are devices intended to reduce vibration at a single specific frequency.

Vibration Acceleration Monitors are compatible with piezo & voltage output accelerometer inputs and provide a 4-20 mA output proportional to the overall measurement. Each unit provides power for the associated transducer, processes the vibration signal to determine overall amplitude and outputs a 4-20 mA dc current that is proportional to a user specified range such as 0-5 g's RMS. These monitors features DIN rail mount, fault detection, buffered transducer output, filter option, alert & danger alarms and remote reset.