Small Injection Molding Machine is capable of molding up to a half ounce of plastic. It allows for direct injection onto the actual component and eliminates spurs and runners. The machine's combination of injection plunger and plasticizing screw delivers highly accurate mouldings of consistent high quality. It is less complicated, can be produced more economically and in dramatically shorter lead times. It is involved in tool and material changes on a larger machine can be reduced to minutes. It provides logical and economical solution. Melt temperature is monitored and controlled from the point of entry. It requires no lubrication and ideal for clean room application. It is powered by a single-phase 13-amp plug so installation and commissioning are straightforward and cost effective.
Small Interface Meters are used in shallow monitoring wells and gas drive pumps for ground water remediation pumping. They provide a small low cost high quality meter for use in shallow monitoring wells. These are fully encapsulated for environmental protection.