Exhaust flow meter is designed to operate over a wide dynamic range, at temperatures up to 1000°F. The signal output is directly proportional to the volumetric flows and can be used to calculate mass flow. The features of this flow meter include no moving parts and low-pressure drop. It is ideal for all exhaust flow measurement applications.

Exhaust gas analyzers are used to make direct and ambient exhaust gas measurements for tuning and preventative. These are ideal for residential to commercial service technicians and safety inspectors to verify the safe operation of furnaces. These are also used for periodic monitoring of target gases in process and in system maintenance applications with consequences for exceeding concentration thresholds.

Exhaust Gas Temperature Sensors are designed to perform in rigorous conditions. It has high-vibration environment associated with diesel engines. They also have integrally mounted hermetic seals, preventing moisture and dirt from infiltrating the cable. It helps with routine maintenance, providing continuous data on variations within an engine. These are placed or threaded directly into diesel engine cylinders to measure exhaust temperatures. It is based on a type K thermo couple, which measures temperatures up to 800 °C. It can be used for measuring and regulating exhaust gas from diesel engines, turbines and compressors within stationary and marine applications. The device is connected to a control air system via tubing and fittings. It can be used for measuring and regulating exhaust gas from diesel engines, turbines and compressors within stationary and marine applications.

Explosion Proof Pressure Sensor is constructed with wetted parts, which promote long life and resistance to media corrosion. These sensors provide measurement in a sealed gauge up to 10,000 psi. Sensors are calibrated and temperature compensated to ensure stability over specified ranges. The sensors have an accuracy of less than 0.25% at 77 F (25 C) and long-term stability of 0.25% full-scale output per annum.

Extractive Probes are made of materials that are impervious to the high temperatures and chemical composition of the stream. Extractive probes catalyze heterogeneous reactions in flue gases.

Factory calibrated pressure switch utilizes a snap-acting stainless steel diaphragm that reverses its curvature when pressurized to a customer specified actuation pressure. When the disc snaps it opens or closes a set of electrical contacts by means of a transfer pin. Resetting the switch occurs automatically when pressure drops below the release value. The unique latching mechanism in this assures safe electrical cutout even if the reset button is held fully depressed. It also prevents the consumer from restarting the equipment until the line pressure has dropped below the release setpoint.

Female Adapter joins a male threaded pipe section to a section of copper pipe or tubing. The female adapter screws onto the male pipe, providing a means by which a copper pipe can be connected to the circuit.

Female Branch Tee connects fractional tubes to male NPT threads. These types of fittings come in inch & metric size tubing and are widely used in a number of industries.