Flange Facing is referred to as a raised face because the gasket surfaces are raised .060″ or .250″ above the bolting circle face. Flange facings are machined and may be either phonographic serrated or concentric serrated. Flange facing services include raised face flanges, flat face flanges, re-face valve seats & compressors, lens ring flanges, O-ring grooves and channel heads.

Flange gaskets prevent leakage of liquids or gases by forming impervious barriers between mating flanges. There are three types of flange gaskets: conventional compression gaskets of cork, paper, rubber, metal, and other asbestos-free materials; cured-in-place liquid compression gaskets cured in seconds with UV light prior to assembly; and formed-in-place liquid gaskets cured after the parts are assembled.

Flange installation gasket kits are designed to maintain the integrity and the reliability of the pipeline and piping system through safety and corrosion protection. They provide both an effective seal and reliable electrical insulation of flanges. It is used to control losses due to corrosion. They can be used to control stray electric currents in piping at oil, gas, water, refinery, and chemical plants, to increase the effectiveness of cathodic protection systems. These are individually and securely packaged in a reinforced corrugated cardboard box, which is clearly labeled as to its contents for convenience in warehousing and field use.

Flange insulation kits are available for all flange sizes, types, pressure ratings and materials. Each kit is individually and securely packaged in a reinforced corrugated cardboard box, which is clearly labeled to contents for convenience in warehousing and field use. Flange insulation kits consist of steel washer, insulating washer, insulating sleeve and type 'E' neoprene faced phenolic gasket. Flange insulation kits are the most widely used form of controlling losses due to corrosion. Flange installation gasket kits are designed to maintain the integrity and the reliability of the pipeline & piping system through safety and corrosion protection. Flange Insulation Gasket Kits provide both an effective seal and reliable electrical insulation of flanges.

Flange joint leakage is a most common maintenance problem in refineries and chemical plants. This leakage can be measured by the effect of external loads on the strength and leakage behavior of flanged joints. The replacement of gasket or O-ring can rectify this leakage problem.

Flange joints are used to connect pipes in dust and fume control applications, in outdoor applications, and for additional strength in high positive or high negative pressure applications. These are fastened with bolts for permanent installations and for installations where the pipe must mate with fans or other air moving equipment.

Flange Line Up Pins assist the pipe fitter in aligning flanges for welding quickly and accurately. It is available in both slide-locking, and wobble-nut models, and in Stainless Steel. It is used to separate pipe flanges. It set precise two-hole horizontal alignment for welding flange assemblies. The cone-shaped end piece automatically centers on the bolt holes. It fit bolt diameter 5/8″ to 1 7/8″. Expansion springs allow pins to give as flanges expand during heating. It has the slide-lock locking for fast set up and stainless steel standard. The Slide-lock locking ends slip on and off quickly and easily, and facilitates quick movement from flange to flange.It is used for maximum clamping power and hardened tool steel for long lasting use.