PC Auto Tensile Tester is suitable for in the test of physical mechanical properties of plastic films, laminated films, flexible packaging materials, adhesives, adhesive tapes, pressure sensitive tape, rubber, paper and aluminum-plastic boards. It is used to test of tensile, tensile resistance and elongation ratio test, hot seal strength, tearing strength, 180 degree peel and 90 degree peel. It is designed and manufactured based on mechanical-electrical integration according to GB/T 17200 and each function fully conforms to relative test standards. It characteristics includes LCD displays data and value, super precision up to ±0.5% of force reading, changeable test range, rated force, elastic modulus, and curve analyzed repeatedly, super long stroke, satisfy requirement of materials with big distortion. It is made up with force load cell, transmitter, micro-processor, load driver, computer and printer and designed based on human engineering. It includes multiple analysis of batch of test curves, rated tensile and elastic modulus which enable users to obtain the quality controlling parameters.

Pharmaceutical package testing can be regarded as a two part process. Package testing system should include package integrity (leak) testing and seal strength testing, two complementary but very different procedures. Both testing modes are important for final package analysis. The tm electronics bt-1000 automated package tester provides seal strength and package integrity testing in one instrument, and also provides the documentation necessary for the packaging process validation and control. In order to produce acceptable packaging on a daily basis and throughout a determined shelf life validation, it is important to evaluate the strength characteristic. The microbial barrier properties of the package materials and design must be evaluated after exposure to the environmental and dynamic stresses expected for the finished package. Several methods may be used to satisfy these requirements. They involve evaluating the material performance itself and the whole, finished package as produced on the packaging line. In order to maintain the sterility of a packaged product until it reaches its point of end use, the package must have a microbial barrier in its post-sterilization environment. The manufacturer must demonstrate that, under the rigors of distribution, storage, handling, and aging, the sterile package integrity is maintained at least for the claimed shelf life of the medical device or product.

Pipe Scanning Service offers a fast, effective means of locating blockages. Typical applications of pipe scanning are determining the presence & quantifying the thickness of ice, water, scale or polymer and online monitoring for slugging or carryover of material.

Pipe scanning system contains four scanning heads, which are spaced at 90 degrees around the interior of the pipe circumference, and are pressed against the walls pneumatically. The scanning heads use rolling transducer assemblies to receive the signals from solenoid impactors mounted adjacent to the receivers. As the scanner assembly is pulled down a pipe, data is collected sequentially from each scanner head, resulting in a linear test spacing of about 6 cm per test. The data is collected into a large data file and saved. Analysis of the data results in plots of distance versus effective pipe wall thickness for each of the scanner heads, which reveals any areas of delamination or other defects. Testing rates in clean pipe have been found to be about 6 m (20 feet)/ 5 minutes forth prototype system, not including initial set-up and takedown time.